Skip to content

Use with AI

Use with AI

Change the IP address of the robot ​

This article describes how to display and change the IP address of the robot. This is important for a variety of applications, especially when using the TCP/IP interface.

This article is valid for all horstOS versions as well as horstFX.

1. Introduction ​

By default, the robot expects to be assigned an IP address through DHCP. However, if the external device does not provide this, the robot's IP address can be changed. This guide provides the necessary steps to do so. The setup only needs to be done once.

2. Finding out the current IP address ​

To find out the current IP address of the robot, you need to select the "External Control" button in the main menu.

Homescreen

In horstOS, you can access external control via the start menu to the apps and select the "External control" app.

horstOSAppsEN

Afterward, the following view should be visible. The current IP address of the robot can be read from the text field under "URL:". Alternatively, clicking on "Show all URLs" will display more information.

ExternalControl

3. Setting up the Connection ​

Establishing the Hardware Connection

Connect the control cabinet to an external device using an Ethernet cable.

Connect the mouse and keyboard to the back of the horstPANELS using the available USB ports.

3.1 Opening network properties in horstOS ​

To open the network properties in horstOS, click on the button at the bottom left.

horstOSnetworkstatusEN

To set up and add the network connections, you can continue with chapter 3.4.

3.2 Switching to the Desktop ​

To switch to the desktop, simply click on the "Exit" button in the horstFX application. Alternatively, you can use the keyboard shortcut Illustration: 3.2 Switching to the Desktop+ Illustration: 3.2 Switching to the Desktopto navigate directly to the desktop.

3.3 Opening Network Properties ​

To open the network properties, simply right-click on the button Illustration: 3.3 Opening Network Properties. This will allow you to access the settings menu by selecting "Edit Connections...".

Illustration: 3.3 Opening Network Properties

3.4 Adding a Network Connection ​

To add a new connection, simply click the button Illustration: 3.4 Adding a Network Connection.

3.5 Creating an Ethernet Connection ​

Select "Ethernet" as the "Connection Type". Then, click the "Create" button to create a new Ethernet connection.

Illustration: 3.5 Creating an Ethernet Connection

3.6 Setting up the Ethernet Connection ​

To set up the Ethernet connection, first select the "IPv4 Settings" tab. Then, you can give the new connection any name you prefer.

For the method, select "Shared to other computers".

If you want to use a static IP address, choose the "manual" method and assign an IP address using the "Add" option.

Clicking on "Save" will save the settings.

Illustration: 3.6 Setting up the Ethernet Connection

3.7 Checking the Network Connection ​

To check the network connection, click on the "network connection" button on the top right corner with your left mouse button. Make sure the connection is displayed. It can also be helpful to disconnect the connection once (by selecting "Disconnect") and then restore the connection.

Illustration: 3.7 Checking the Network Connection

To verify if the IP address has been successfully assigned to HORST, go back to horstFX in the main menu under the "External Control" tab and check if the newly assigned IP address is listed there (see section "Finding out the current IP address").

If the IP address is not listed, you will need to repeat steps one to six.