Skip to content

Use with AI

Use with AI

Robot base accessories: Tray holder with legs (assembly aid) ​

Figure: Robot base accessories: Tray holder with legs (assembly aid)

General information ​

Note

This document is intended solely as an aid to the assembly of the Component Kit. It does not replace the applicable assembly instructions.

Safety notice

Get professional assistance if necessary to avoid dangerous situations and injuries

Assembly parts ​

No.QuantityDesignation
11Tray holder (flat or inclined)
22Legs with adjustable feet
34Floor mounting set (cylinder head screw DIN 912 M10x30, washer DIN 125 M10, impact anchor M10x30)

Figure: Robot base accessories: Tray holder with legs (assembly aid)

Required tools ​

  • Hexagon key 8mm
  • Open-end wrench 17mm

Assembly steps ​

The tray holder can be screwed directly to the corners of the robot base using four cylinder screws DIN 912 M10x30 (not included).

Figure: Assembly steps

The tray holder with legs is anchored to the floor with the included floor mounting kit.

Figure: Assembly steps

Alternatively, the tray holder with legs can also be screwed directly to the corners of the robot base using four cylinder screws DIN 912 M10x30 (not included).

Figure: Assembly steps

Mounting position ​

The tray holder can be mounted on three sides of the robot base.

Figure: Mounting position

In addition to the upper mounting position, the tray holder can be mounted at two other heights on the robot base (height difference 100mm each).

Figure: Mounting position

Figure: Mounting position

The tray holder with legs can also be mounted on three sides of the robot base.

Figure: Mounting position