Skip to content

Use with AI

Use with AI

Robot base accessories: height extension module (assembly aid) ​

Figure: Robot base accessories: height extension module (assembly aid)

General Information: ​

The addition of the Extension Module allows for the robot base to be raised by 20cm (1 Extension Module) or 40cm (2 Extension Modules).

Note

This document serves as a guide for assembling the Component Kits. It is not a step-by-step installation manual.

Safety notice

Seek professional assistance if necessary to avoid dangerous situations and injuries.

Safety notice

Up to 2 Extension Modules can be stacked on top of each other on the robot base to ensure stability.

Safety notice

When using the robot base with the Extension Module, it is important to secure the robot base to the ground to ensure stability and prevent tipping.

Assembly Parts: ​

Nr.QuantityDescription
11Extension Module
24DIN 912 M10x30
34DIN 985 M10

Figure: Assembly Parts:

Required Tools: ​

  • Hex key 8mm
  • Open-end wrench 17mm

Assembly Steps ​

  1. The Extension Module is attached to the designated screw points on the robot base using the provided screws and nuts.
    Figure: Assembly Steps
  2. To raise the robot's position by 40cm, you can stack up to two Extension Modules.
    Figure: Assembly Steps
  3. The robot is mounted on the Extension Module using the screws and nuts provided with the robot.
    Figure: Assembly Steps

Assembly Positions ​

In addition to the central mounting position, there are three other mounting positions available at the edge of the robot base. These are illustrated in the following diagram:

Figure: Assembly Positions